Static Jack System
Static Jack System
Static Jack System
Exactly Capturing the Strength Characteristics of Structures
The servo actuator system applies static test force loads on structures at high precision to obtain their mechanical characteristics on an experimental basis.
[Features]
- Displacement is controlled in a stepped manner by using a monitor control wave, and successively and repeatedly increased and decreased to measure strain at each point, displacement and other parameters to obtain static strength characteristics.
- Various combinations of servo actuator and hydraulic power supply capacity are possible according to the aim of the experiment and scale.
- Pseudo-dynamic test software is available.
[Specifications]
■ 1000 KN Type
| 1-unit Configuration | 2-unit Configuration | |
|---|---|---|
| Test load capacity | 1000 KN | 1000 KN |
| Piston stroke | ±200 mm | ±200 mm |
| Hydraulic power supply capacity | 40 L/min | 40 L/min |
■ 2000 KN Type
| 1-unit Configuration | 2-unit Configuration | |
|---|---|---|
| Test load capacity | 2000 KN | 2000 KN |
| Piston stroke | ±300 mm | ±300 mm |
| Hydraulic power supply capacity | 40 L/min | 40 L/min |
■ 3000 KN Type
| 1-unit Configuration | 2-unit Configuration | |
|---|---|---|
| Test load capacity | 3000 KN | 3000 KN |
| Piston stroke | ±300 mm | ±300 mm |
| Hydraulic power supply capacity | 40 L/min | 40 L/min |
■ 5000 KN Type
| 1-unit Configuration | 2-unit Configuration | |
|---|---|---|
| Test load capacity | 5000 KN | 5000 KN |
| Piston stroke | ±300 mm | ±300 mm |
| Hydraulic power supply capacity | 70 L/min | 70 L/min |
[Evaluation Targets]
Structural material testing
* Appearance and specifications are subject to change without notice.
This page may contain references to products that are not available in your country.
Please contact us to check the availability of these products in your country.